Variability in total shoulder arthroplasty planning software compared to a control CT-derived 3D printed scapula. Academic Article uri icon

Overview

abstract

  • BACKGROUND: Two techniques exist from which all 3D preoperative planning software for total shoulder arthroplasty are based. One technique is based on measurements constructed on the mid-glenoid and scapular landmarks (Landmark). The second is an automated system using a best-fit sphere technique (Automated). The purpose was to compare glenoid measurements from the two techniques against a control computed tomography-derived 3D printed scapula. METHODS: Computed tomography scans of osteoarthritic shoulders of 20 patients undergoing primary total shoulder arthroplasty were analyzed with both 3D planning software techniques. Measurements from a 3D printed scapula (Scapula) from the true 3D computed tomography scan served as controls. Glenoid version and inclination measurements from each group were blinded and reviewed. RESULTS: In 65% (Automated) and 45% (Landmark) of cases, either inclination or version varied by 5° or more versus 3D printed scapula. Significant variability in version differences compared to the scapula group existed (p = 0.007). Glenoid version from the Scapula = 13.0° ± 10.6°, Automated = 15.0° ± 13.9°, and Landmark = 12.2° ± 7.8°. Inclination from Scapula = 5.4° ± 7.9°, Automated = 6.1° ± 12.6°, and Landmark = 6.2° ± 9.1°. DISCUSSION: A high percentage of cases showed discrepancies in glenoid inclination and version values from both techniques. Surgeons should be aware that regardless of software technique, there is variability compared to measurements from a control 3D computed tomography printed scapula.

publication date

  • December 2, 2019

Identity

PubMed Central ID

  • PMC8513001

Scopus Document Identifier

  • 85065576171

Digital Object Identifier (DOI)

  • 10.1016/j.jses.2018.06.003

PubMed ID

  • 34659466

Additional Document Info

volume

  • 13

issue

  • 3